[ph3d]

Everything went successful here as far as the QPST section and successfully copied the files to the device but still nothing from the TP

If I hold power + home then nothing happens at all - no device is detected -

If I hold power + volume down it goes back to qualcomm hd usb loader

If I hold power + home + volume up it shows as a palm device but webos doctor still cant see it

Looks like I have got a hardware failure possibly going to leave it for a while and charge it again on usb for a few days then give it another go

Edited by ph3d, 22 November 2012 - 01:34 AM.

[jcsullins (OP)]

ph3d, on 22 November 2012 - 01:32 AM, said:

Everything went successful here as far as the QPST section and successfully copied the files to the device but still nothing from the TP

If I hold power + home then nothing happens at all - no device is detected -

If I hold power + volume down it goes back to qualcomm hd usb loader

If I hold power + home + volume up it shows as a palm device but webos doctor still cant see it

Looks like I have got a hardware failure possibly going to leave it for a while and charge it again on usb for a few days then give it another go

No, it sounds like you may have a bad bootie configuration. Should be able to get around that. Will post more details in next few days.

[ph3d]

jcsullins, on 22 November 2012 - 01:51 AM, said:

No, it sounds like you may have a bad bootie configuration. Should be able to get around that. Will post more details in next few days.

I will stay tuned, thanks for the help sir you are a legend!

[cyberprashant]

jcsullins, on 22 November 2012 - 01:51 AM, said:

No, it sounds like you may have a bad bootie configuration. Should be able to get around that. Will post more details in next few days.

That's exactly where mine is at - i was able to sucessfully run the TP debrick but mine is doing exactly what ph3d reports.

Thanks for your continued work on this jscullins!

[jcsullins (OP)]

cyberprashant, on 22 November 2012 - 04:14 AM, said:

That's exactly where mine is at - i was able to sucessfully run the TP debrick but mine is doing exactly what ph3d reports.

Thanks for your continued work on this jscullins!

Let it charge on AC charger for a few hours and see what happens ...

[jcsullins (OP)]

gsausalito, on 21 November 2012 - 07:49 PM, said:

HI:

First of all, great job!

Second: May my 64GB Touchpad be cured?

Regards from Spain

Should have updated version with 64G config soon.

[sieve wang]

my pc asked me a dirver of "qualcomm cdma technologies msm" that after:

Begin download to port COM4 using files:
D:\webos soft\TPDebrick_v01\EMMCBLD.HEX
D:\webos soft\TPDebrick_v01\8660_msimage.mbn
Download completed - no errors detected
Timeouts: 1st dev arrival 60000 ms, linger time 10000 ms

[ph3d]

Yup same here sieve I would keep going with the process as documented and just cancel that driver installation

[sieve wang]

no ，you should install the dirver,then your pc will find a new disk,then the emmcsd will show what it should be.i did it just now.

Edited by sieve wang, 22 November 2012 - 06:37 AM.

[tolookah]

What windows os were you using? I had bad luck with vista, will not have access to other OS versions until next week (i think)